One possible solution is – Press from left to right (1-5): Buttons 5 4 1 2 4 5 2 5. Another solution is 1 1 2 2 4. If mistake is done go back to the saved game. Go forward on the corridor.
Where are the tumbler ramps in Mysterious Journey 2?
Go to the end and turn left. The right path is blocked by an erratic laser beam. Go forward and left across the ramp. Take the open passage seen at the right. The passage has 2 walkways on both sides that ends on top of a ramp. Rotating Corridorpuzzle- Ahead are eight tumbler ramps that should be reset to form a corridor.
How to center talen in Mysterious Journey 2?
Go back to where the electric discharge used to be, walk past it, and up to the right. Look through the window and note the position of the bars blocking the shuttle bay door. The goal is to center all four. Go back to the end of the corridor where you picked up the first power chip for Talen.
How do you start laser flow in Mysterious Journey 2?
1. Enter and see the elevator on the right. 2. Go to lamp. Look down and press button to start laser flow. 3. Turn pod behind the lamp (now called start pod) 2xs. 4. White circles- Follow the black arrows and the white circles (pods) while turning the pods as noted with black numbers on the graph.
One possible solution is – Press from left to right (1-5): Buttons 5 4 1 2 4 5 2 5. Another solution is 1 1 2 2 4. If mistake is done go back to the saved game. Go forward on the corridor.
Go to the end and turn left. The right path is blocked by an erratic laser beam. Go forward and left across the ramp. Take the open passage seen at the right. The passage has 2 walkways on both sides that ends on top of a ramp. Rotating Corridorpuzzle- Ahead are eight tumbler ramps that should be reset to form a corridor.
How to make a telescope in Room 3?
1. The circular device has few pieces: a base layer, a needle, a small circle, and a large circle. Look closely, you will see four red gems on the base layer. 2. Rotate the pieces so all the gems illuminate. Solution is shown in the picture below. 3. Get an etched glass disc. Locate a round capsule on a table. 1. Turn the switch on top.
1. Enter and see the elevator on the right. 2. Go to lamp. Look down and press button to start laser flow. 3. Turn pod behind the lamp (now called start pod) 2xs. 4. White circles- Follow the black arrows and the white circles (pods) while turning the pods as noted with black numbers on the graph.
